Jeld-wen JII024 Wood/Clad Wood Windows with Exterior Trim o User Manual download pdf (Page 6)

INSTALLATION INSTRUCTIONS

for Wood/Clad Wood Windows with Exterior Trim or Nail Fin (JII024)

INSTALL WINDOW - CONTINUED

APPLY DRIP CAP TO WINDOWS WITH EXTERIOR TRIM

APPLY THE SELF-ADHESIVE FLASHING

Note! Keep the edge of the

self-adhesive ashing as

close to the window frame as

possible and apply over the

nail n.

1. Apply the side pieces

starting 2" above the header

and overlap the ashing on

the sill as shown.

2. Center and apply the header

piece above the header,

overlapping the side pieces

as shown.

3. Press the ashing down with

a J-roller, being careful to

remove any gaps or bubbles

beneath self-adhesive

ashing (remove and

replace if necessary).

1. Cut a piece of drip cap the

length of the header trim

+ 1/4" to allow for 1/8"

overlap past the ends of the

trim.

2. Apply 1/4" bead of sealant

to header trim as shown.

3. Center the drip cap on the

trim and nail in place as

shown.

4. Apply sealant underneath

the drip cap where it meets

both ends of the trim.

FLASH WINDOW - WINDOWS WITH A NAIL FIN INSTALLED INTO STUD-FRAMING ONLY

Cut pieces of self-adhesive ashing as follows:

DP50 or below

(4" ashing)

Above DP50

(6" ashing)

One header piece 10" longer than the

header

14" longer than the

header

Two side pieces 8" longer than the

jamb

12" longer than the

jamb

SPRAY ADHESIVE/PRIMER

Apply spray adhesive (protect

window from overspray) to

nailing n and building wrap

around the window as shown.

1 2 3 4 5 6 7

Comments to this Manuals

No comments

Jeld-wen JII024 Wood/Clad Wood Windows with Exterior Trim o User Manual Page 6

Comments to this Manuals

Related products and manuals for For Home Jeld-wen JII024 Wood/Clad Wood Windows with Exterior Trim o