Jeld-wen JII026 Wood Patio Doors with Exterior Trim or Nail User Manual Page 2

  • Download
  • Add to my manuals
  • Print
  • Page
    / 8
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 1
INSTALLATION INSTRUCTIONS
for Wood Patio Doors with Exterior Trim or Nailing Fin (JII026)
2
FULLY SHEATHED WALL CONSTRUCTION
The wall framing is
covered by sheathing
and the door will be
mounted with the
nailing n/exterior
trim ush against
the sheathing. This
installation assumes
building wrap is
properly installed
prior to installation.
OPEN-STUD CONSTRUCTION
The wall framing needs to be covered by backing support before the
patio door can be installed. The door will be mounted with the nailing
n/exterior trim ush against the applied backing support.
This backing support should be a non water-degradable, thin (max. 1/8"
thick) sheet material such as vinyl sheeting. Completely surround the
rough opening with the backing support as shown. Backing support
must be applied before building wrap.
This installation guide specically addresses masonry/block wall,
sheathed wall and open-stud construction.
MASONRY/BLOCK WALL CONSTRUCTION
This installation
assumes that a
building professional
has already properly
fastened and sealed
a framework of studs
(often called a buck)
to the concrete/
masonry wall.
MATERIALS
Finned products: 1 3/4" galvanized roong nails; Exterior trim
products: 3" galvanized casing nails. Fasteners must penetrate at least
1" into framing.
3/16" x 2 1/2" self-tapping concrete screws (for concrete suboors)
Builders doors with a berglass sill will include a square drive bit,
9 - #8 x 1.5" screws for wood suboors, 4 - #10 x 3" strike plate and
2 - #8 x 2" head bracket replacement screws.
Non water degradable or compressible shims
4", 6", or 9" (as required by local code and window conguration)
wide self-adhesive ashing: We recommend OSI
®
QUAD
®
Butyl
Flashing Tape or equivalent.
Spray adhesive/primer for self adhesive ashing. Such as Loctite
®
300
or equivalent
Polyurethane low expansion Window and Door foam: We recommend
OSI
®
QUAD
®
Foam or equivalent).
NEEDED MATERIALS AND TOOLS
Sealant: We recommend OSI
®
QUAD
®
Max Sealant or equivalent. This
can be used in any application and can be painted or ordered in a
color matched product, if desired.
Plastic drain screen with crisscross or woven pattern (sold in 6" widths
to protect rain gutters) for step-down landings
Sheet metal ashing or bendable vinyl sheeting for sill pan (6" wide
for 2" x 4" wall)
Note! Follow all material manufacturers’ instructions for proper use
and compatibility.
TOOLS
Cutting shears (sill pan)
Tape measure
Utility knife
Level (4’ minimum
recommended)
J-roller
Caulking gun
Drill
Construction stapler
Flat head screwdriver
SAFETY
Read and fully understand ALL manufacturers’ instructions
beforebeginning.
Do not work alone. Two or more people are required. Use safe
liftingtechniques.
Use caution when handling glass. Broken or cracked glass can cause
serious injury.
Wear protective gear (e.g. safety glasses, gloves, ear protection, etc.).
Operate hand/power tools safely and follow manufacturer’s
operatinginstructions.
Use caution when working at elevated heights.
SAFETY AND HANDLING
MATERIALS AND PATIO DOOR HANDLING
Make sure the operating panel is secured prior to installation.
Heed material manufacturers’ handling and application instructions.
Protect adhesive surfaces from dirt, moisture, direct sunlight and
folding over onto themselves.
Handle in vertical position; do not drag on oor.
Do not put stress on joints, corners or frames.
Store patio door in dry, well-ventilated area in vertical, leaning
position to allow air circulation; do not stack horizontally.
Protect from exposure to direct sunlight during storage.
Install only into vertical walls and when conditions and sheathing
aredry.
IF INJURY OCCURS, IMMEDIATELY SEEK MEDICAL ATTENTION!
ROUGH OPENINGS
Buck
Trimmer
studs
Header
Sheathing
Sill area
King
stud
Page view 1
1 2 3 4 5 6 7 8

Comments to this Manuals

No comments